Release Call
N2FE Flow Operation - Release Call
The ReleaseCall operation forces termination of the call with a non-standard release cause, to
indicate that the call has failed for a special reason. Typical examples of this might be
to indicate that the call was received from an out-of-zone area.
The ReleaseCall operation has no exits. No further processing can occur after this operation.
Config Parameters
The ReleaseCall operation config attributes are as follows.
| Parameter | Type | Description |
|---|---|---|
cause
|
Integer |
The release cause. Integer in the range 1-31. However, if it should never be necessary to
specify release cause 31, as release cause 31 is the default behavior in the case where
a call ends without any explicit handling defined.
|
Example Operation
Here is an example ReleaseCall operation in JSON representation.
{
"id": 15,
"type": "ReleaseCall",
"base_node": 22,
"config": {
"cause": 1
},
"exits": []
}
In this example:
- The call is released with INAP release cause
1. - No further processing will occur.
Exits
This operation type does not allow any exits.